A Catalog Number Cannot Describe Every Installation
Although an RF system upgrade might appear simple in theory, upon inspection of the site where the equipment will be placed (i.e., existing antennas, racks, etc.), you discover limitations of the available rack space, proximity issues of the proposed channels to each other/other transmitters, and/or RF paths do not support the proposed new layout of the existing equipment. These are typically not major site changes but rather the reason to analyze if a generic RF device fits your specific application. Generic devices can meet one requirement (frequency coverage) and fail others (isolation, insertion loss, power level, size).
There Are More Than Just Frequencies To Be Specified
Even two sites in the same frequency band have different application requirements. A generic filter designed to work well in one location will likely provide too little attenuation for adjacent unwanted frequencies in another. An RF transmitter combiner purchased strictly based on channel count will not address channel spacing nor possible interference from transmitters located nearby.
To begin, identify the entire frequency plan. This means determining desired transmitting and receiving frequencies, frequencies of nearby carriers that may interfere with your RF system’s performance, power levels of both transmitters and receivers; and maintaining specified performance. In many instances, particularly those involving multiple tenants in a shared site environment, how much noise from transmitters reaches a receiver, and potential for receiver desensitization are critical factors along with meeting the desired channel specifications. The proper design should depend on measurement data collected under the site’s current conditions and meet the necessary engineering specifications – not whether the manufacturer supplies a device capable of supporting the desired frequency range.
Physical Constraints Often Exist At Active Sites
Reconfiguring equipment at operational communication sites is rarely done as a “clean sheet”. Existing antenna installations may be occupied, racks are pre-allocated spaces, and deactivating operational channels during this time may be impractical. Additionally, retaining compatibility with previously installed equipment is often necessary when increasing capacity or altering frequency plans. Physical considerations must be taken into consideration along with RF performance characteristics. Dimensions and mounting configurations of custom products must be evaluated equally to their electrical properties. Additional considerations include connector locations, ease of maintenance/access for tuning/testing, and post-installation capability to verify system operation. For instance, a system may require a custom-designed filter that provides sufficient isolation to fit within an existing cabinet. Conversely, a system may require a custom-designed transmitter combining arrangement that corresponds to its unique channel plan. While neither example supports the notion that custom equipment is always the most advantageous option; they illustrate the necessity of understanding an application prior to specifying the associated hardware.
Good Custom Design Starts With Good Site Information
Providing information regarding the problematic condition and site-specific details will assist in creating a more useful specification for special components. Examples of site-specific information include frequency assignments, transmit power levels, receiver configurations, available space for equipment installation, antenna arrangements, and past measurements. By providing additional detail relative to the application problem(s), the engineer can create a clearer picture of what the component must accomplish. On-site measurements/spectrum analysis/data collection and receiver testing may aid in establishing whether proposed changes adequately resolve the source of interference issues. In many situations, simply replacing equipment without identifying/uncovering the root causes of unwanted signals entering the receiver path will merely result in leaving the original problem(s) uncorrected.
TX RX Systems provides RF design/engineering services for custom filters/transmitter combining systems/isolators/couplers/etc. As part of its published engineering process, TX RX evaluates customer requirements and develops custom RF equipment solutions to meet those requirements. TX RX Systems also provides RF testing/services that may aid in documenting site-specific data prior to finalizing a design/configuration.
Custom Does Not Necessarily Equate To A New Design From Scratch
On occasion, an application may be resolved through modification of a known design or selection of alternate configurations of existing components. In other applications, new designs will be developed due to multiple electrical/mechanical requirements that must be satisfied simultaneously. Ultimately, the determination should be made by evaluating technical requirements/design availability/schedule/timeframe for testing.
Regardless of whether custom equipment is ultimately developed or modified to meet customer needs, it is essential that clear acceptance criteria exist for evaluation purposes. Evaluation of design characteristics should correspond to desired frequency response/insertion loss/rejection/isolation/power level/installation constraints as applicable. Verification of characteristic(s) via testing should occur prior to relying on custom-developed equipment in service.